TGP Systems

TGP Test Center

As TGP Test Center we always work for your comfort with our experienced staff.

As TGP Test Center we always work for your comfort with our experienced staff.

SALT SPRAY TEST

TGP fortefine is a special coating process of TGP Systems. The process is alcaline zinc coating + special passivasion + special finishing. Coating is one of the important specification of products especially for some environmetal conditions with high salty (coast), pollution or humidity. TGP Test Centre has a salt spray test chamber to check the quality standart of the production in each batch. Thanks to fortefine coating,red corrosion of TGP product is minimum 500 hours which is much higher than the world standart (240 hours) indicated in EN 13126-1, EN 1670 and EN ISO 9227.

CYCLE TEST TGP multipoint door lock is applied in a test of 200.000 complete cycles (cycle: close- open) with a frequency of 250 cycles /hour, for a total of 400.000 movements. (Refer to EN 13126-4)

ENDURANCE TEST TGP multipoint door lock is applied in a test of 25.000 complete cycles (cycle: open-close) with a frequency of 250 cycles /hour, with 70 N force. (Refer to EN 13126-4)

FATIGUE TEST TGP Tilt&Turn system is applied in a test of 15.000 complete cycles (cycle: open- close - tilt- close ) with a frequency of 250 cycles /hour, for a total of 60.000 movements. (Refer to RAL GZ 607/3)

FATIGUE TEST AT 90° TGP Tilt&Turn system is applied in a test of 10.000 complete cycles, (cycle: open-close) sash at 90° with a frequency of 250 cycles/hour, for a total of 20.000 movements. (Refer to RAL GZ 607/3)

OVERLOAD TEST An additional load of 1.000 Newton (100 kg) , the sash positioned at 90°, for 5 minutes is applied on the window with TGP Tilt&Turn system . (Refer to RAL GZ 607/3)

OBSTACLE TEST An obstacle is installed on the frame and accelerated a 10 kg weight from a height of fall of 200 mm, repeated 3 times. (Refer to RAL GZ 607/3)

Other Content